Williams · Data East

System 9 – 11C

FPGA MPU replacementPart no. WillFA11
FPGAWilliams SYS11CData East

FPGA replacement for Williams System 11C and the full Data East range.

$450CADSold out
The WillFA11 is sold out. We'll email you when the next batch is ready.
Data East DMD speed issue (firmware v0.92): Data East DMD games run faster than intended on the current firmware. Williams SYS11C and Data East alphanumeric games are unaffected. Under active investigation; check lisy.dev/willfa11 before ordering for DE DMD titles.
  • Tested before shipping
  • Ships from Canada
  • Solenoid pulse protection built in
  • Ships in 2 - 3 Business Days · Canada only · Free shipping until December 25

Open-hardware design

The WillFA11 is an open-hardware design by Ralf Thelen, published at lisy.dev under the Creative Commons Attribution-ShareAlike 4.0 (CC BY-SA 4.0) license. Drop Targets assembles, programs and bench-tests each board in Kingston, Ontario.

Built to Ralf's published design, with his references left on the board. Documentation, schematics and source files are on lisy.dev.

For every one of these boards we sell, $5 goes into a fund donated at the end of the year, in Ralf's name, to a charity local to him.

All sales final. Boards are bench tested before shipping; make sure your machine has no shorts or wiring faults before installing. Sales policy

User manual (PDF)

About this board

A 1:1 replacement for Williams System 11 and Data East MPU boards. v0.92 covers SYS11C and the full Data East range — alphanumeric through 192×64 DMD. Includes special solenoid pulse-mode: stuck switch won't burn a coil.
  • Ready to install: FPGA and MP3 MiniPlayer already fitted. Nothing extra to buy.
  • FPGA hardware emulation — no OS or software layer
  • Williams SYS11C and full Data East range supported
  • Solenoid pulse protection — stuck switch won't burn coils
  • DIP sockets pre-installed — no soldering required

Tech specs

TypeFPGA MPU Replacement
CoreFPGA (fitted and programmed)
EmulationHardware (FPGA)
Boot time< 3 seconds
Form factorWilliams System 11 / Data East MPU slot (direct drop-in)
ConnectorsOriginal edge connector — no rewiring
NotesSolenoid pulse protection (stuck switch protection)

Installation

Drop-in replacement. Remove original MPU board and install the WillFA11 in the same slot. No jumper changes required for SYS11C or Data East alphanumeric titles. For Data East DMD titles, check lisy.dev/willfa11 for the current firmware status before installing.

Compatible machines (18)

Williams System 9 / 11
Data East

Don't see yours? Ask us before you order.

WillFA11 — Williams SYS11C · Data East Alpha & DMD