Gottlieb

System 1

FPGA MPU replacementPart no. GottFA1
FPGASystem 1

Drop-in FPGA replacement for Gottlieb System 1.

$350CADSold out
The GottFA1 is sold out. We'll email you when the next batch is ready.
Game files not included: Gottlieb boards ship without game ROMs — you'll need to source the files for your machine yourself. We include a pre-formatted SD card already set up for the board, and the instructions show you how to add your ROMs. More in the FAQ.
  • Tested before shipping
  • Ships from Canada — no customs
  • Open-source · lisy.dev
  • Ships in 2 - 3 Business Days · Canada only · Free shipping until December 25

Open-hardware design

The GottFA1 is an open-hardware design by Ralf Thelen, published at lisy.dev under the Creative Commons Attribution-ShareAlike 4.0 (CC BY-SA 4.0) license. Drop Targets assembles, programs and bench-tests each board in Kingston, Ontario.

Built to Ralf's published design, with his references left on the board. Documentation, schematics and source files are on lisy.dev.

For every one of these boards we sell, $5 goes into a fund donated at the end of the year, in Ralf's name, to a charity local to him.

All sales final. Boards are bench tested before shipping; make sure your machine has no shorts or wiring faults before installing. Sales policy

About this board

A 1:1 drop-in replacement for the Gottlieb System 1 MPU. FPGA hardware emulation — fast boot, no OS overhead, no extra features — just faithful original behaviour at low cost. DIP sockets pre-installed by JLCPCB; seat the ICs, load your ROMs, power on.
  • Ready to install: FPGA and a pre-formatted MicroSD card already fitted. Nothing extra to buy.
  • FPGA hardware emulation — no OS or software layer
  • Boot time under 3 seconds
  • DIP sockets pre-installed — no soldering required

Tech specs

TypeFPGA MPU Replacement
CoreFPGA (fitted and programmed)
EmulationHardware (FPGA) — no OS, no PinMAME
Boot time< 3 seconds
Form factorGottlieb System 1 MPU slot (direct drop-in)
ConnectorsOriginal edge connector — no rewiring
NotesNone (standalone MPU)

Installation

Remove the original System 1 MPU board and slide the GottFA1 into the same slot. No jumper changes, no wiring modifications. Power on — boots in under 3 seconds and plays like the original.

Compatible machines (16)

Gottlieb System 1

Don't see yours? Ask us before you order.